TIS EVSE Type 2 Testing Adapter 415V AC IP40 CP/PP Simulation (TISEV-TEST100)
credit
TIS EVSE Type 2 Testing Adapter 415V AC IP40 CP/PP Simulation (TISEV-TEST100)
TIS TISEV-TEST100 is a Type 2 EVSE testing adapter for Mode 2 and Mode 3 charge points, supporting up to 415V AC input with IP40 protection and CAT III 300V measurement category, with CP state simulation (A, B, C, D), PP cable coding (NC, 13A, 20A, 32A, 63A) and Fault PE/Fault E simulation, plus a fused external load function up to 240V AC 10A via the LOAD section; supplied with an integrated 60cm Type 2 plug cable to support safer testing that improves installation quality, reduces rework, and helps deliver efficient, compliance-focused EV charging for lower energy waste.
Reach out to Green2Go's sales team via phone by calling 01424 231585 or via our 'Contact Us' page for bespoke renewable energy solutions. Benefit from expert advice and competitive pricing. Make your sustainable switch today.
KEY FEATURES
- Max input voltage: 415V AC phase-phase, 50/60Hz ±5%
- Measurement category: CAT III 300V (to ground)
- IP40
- Allowed output load: 240V AC, max 10A AC (LOAD section)
- Control Pilot simulation: Status A, B, C, D (ventilation/not ventilation)
- Proximity Pilot simulation: NC, 13A, 20A, 32A, 63A
- Fault simulation: Fault PE and Fault E
- Phase presence indication: LED phase detection
- Integrated Type 2 plug cable, 60cm length
- Standards/guidelines: IEC/EN 61010-1, IEC/EN 61326-1, IEC/EN 61851-1, IEC/EN 60364-7-722
- Standards, IEC/EN61010-1, IEC/EN61851-1 and IEC/EN60364-7-722
- Supplied in a Hard Carry Case with Link Cable for the TIS MFTPRO
Additional Information
- Dimensions (H x W x D) 60 x 115 x 210 (mm)